吃奶呻吟打开双腿做受动态图_制服丝袜熟女AV天堂_边摸边吃奶边做爽动态_三年片大全免费观看_福利一区三区_中文字幕无码91加勒比_男女做高清无遮挡免费视频_曰本凹凸AⅤ视频在线_日本久久精品影片_亚洲精品无码MⅤ在线观看

PACKAGING & STORAGE
VpCI®-389 is available in 5 gallon (19 L) pails, 55 gallon (208 L) metal drums, liquid totes, and bulk.
To ensure best product performance, store in original packaging, indoors, and out of direct sunlight at 40-100 oF (4-38 oC).
Shelf life: 2 years

CHARACTERISTICS/TECHNICAL DATA

All tests performed after a 7 day cure at ambient temperature.

APPLICATION
Surface Preparation
Substrate should be free of grease, oil, dirt, fingerprints, drawing compounds, rust inhibitors (except Cortec® ap- proved), or any other surface contamination that could affect adhesion. For bare metal applications, Cortec® recommends a NACE #3/SSPC-SP6. Consult Cortec® Technical Service and/ or test system adhesion prior to full scale application.

Note: Make sure dew point is more than 5 °F (2 °C) less than air temperature for application. Power agitate to a uniform consistency using a “squirrel cage” type mixer, hand-held drill mixer, or other equivalent method. VpCI®-389 can be applied by spray, roll, brush, or dip.
Typical Equipment Setups HVLP / Conventional Spray
•Tip 0.02”-0.11” (0.5-2.8 mm) dependent upon pressures
and viscosity
•Air Pressure 45-55 psi
•Fluid Pressure 10 psi
•Fluid hose should be ?” (0.95 cm) I.D. with a maximum length of 50 feet (15.2 m). ¼” (0.64 cm) I.D. fluid hose can be used, but pressures may need to be adjusted. Pot should always have dual regulation and be kept at same elevation as spray gun.

Air Assisted Airless / Airless
•Tip 0.015”-0.035” (0.38-0.89 mm) dependent upon pres- sures and viscosity
•Pressure 1800-2500 psi
•Hose should be ?” (0.95 cm) I.D. minimum, but a ¼” (0.64 cm) I.D. whip end section may be used for ease of applica- tion. A maximum length of 100 feet (30.5 m) is suggested.

Cleanup
Clean tools/equipment immediately after use with water when coating is still wet. For removal of VpCI®-389 applied to a metal surface, use a VpCI®-41x Series alkaline cleaner/ degreaser. Follow mfg’s safety recommendations when using any solvent.