吃奶呻吟打开双腿做受动态图_制服丝袜熟女AV天堂_边摸边吃奶边做爽动态_三年片大全免费观看_福利一区三区_中文字幕无码91加勒比_男女做高清无遮挡免费视频_曰本凹凸AⅤ视频在线_日本久久精品影片_亚洲精品无码MⅤ在线观看

VpCI®-369 is an oil-based temporary coating that provides extreme corrosion protection in aggressive environments and is one of our most-popular wet film corrosion inhibitors and lubricants. Can be matched to some custom colors.

Commercial  equivalent  to MIL
– PRF – 16173E (Grades 2), NSN 8030-00-244-1295,  244-1297,
244-1298, 01-149-1731. UFI: 1KTX-A14E-NU18-EAEC PACKAGING & STORAGE
VpCI®-369 is available in 5 gallon (19 L) pails, 55 gallon (208 L) metal drums, liquid totes, and bulk.
VpCI®-369 is also available in 11 oz. (312 g) aerosol cans.
To ensure best product performance, store in original packaging, indoors, and out of direct sunlight at 40-100 °F (4-38 °C).

Shelf life: 2 years

CHARACTERISTICS/TECHNICAL DATA

All tests performed after a 7 day cure at ambient temperature


APPLICATION

Surface Preparation
Substrate should be free of grease, oil, dirt, fingerprints, drawing compounds, rust inhibitors (except Cortec® ap- proved), or any other surface contamination that could affect adhesion. Cortec® recommends a minimum of a SSPC-SP1 over painted surfaces. For bare metal applications, Cortec® recommends a NACE #3/SSPC-SP6. Consult Cortec® Tech- nical Service and/or test system adhesion prior to full scale application.

Power agitate to a uniform consistency using a “squirrel cage” type mixer, hand-held drill mixer, or other equivalent meth- od. VpCI®-369 can be applied by spray, roll, brush, or dip.

Typical Equipment Setups

HVLP / Conventional Spray
•Tip 0.02”-0.11” (0.5-2.8 mm) dependent upon pressures and viscosity
•Air Pressure 45-55 psi
•Fluid Pressure 10 psi
•Fluid hose should be ?” (0.95 cm) I.D. with a maximum length of 50 feet (15.2 m). ¼” (0.64 cm) I.D. fluid hose can be used, but pressures may need to be adjusted. Pot should always have dual regulation and be kept at same elevation as spray gun.

Air Assisted Airless / Airless
•Tip 0.015”-0.035” (0.38-0.89 mm) dependent upon pres- sures and viscosity
•Pressure 1800-2500 psi
•Hose should be ?” (0.95 cm) I.D. minimum, but a ¼” (0.64 cm) I.D. whip end section may be used for ease of applica- tion. A maximum length of 100 feet (30.5 m) is suggested.

Cleanup

Clean tools/equipment immediately after use with Butyl Acetate when coating is still wet. For removal of VpCI®-369 applied to a metal surface, use a VpCI®-41x Series alkaline cleaner/degreaser. Follow mfg’s safety recommendations when using any solvent.